Week 9: Elbow & Wrist Prototyping

Week of November 9-13

This week we moved into phase four (simulation/prototype) of our project plan, building a first iteration of both the elbow and wrist joints, while continuing work on our controls system and electronics.

Elbow and wrist prototypes

Our first elbow prototype showed that the buckles we ordered weren't fastening properly, so we've ordered velcro straps instead. Our elbow V bracket also didn't fit everyone well, so we are exploring a 3D-printed flexible tessellation that can wrap around each person's arm. We also noted some pinching at the inside of the elbow and the joint sliding under the motor's weight, which will feed into the next iteration. For the wrist, we tested a pulley system using bike brake cables, and found that housing and cable length don't affect the design as long as the housing stops at the same point at each end. This means the actuation unit can sit further from the wrist.

Controls and electronics

We refined our MuJoCo simulation of the humanoid and worked on running it on the Jetson. We also soldered and brought up a Teensy microcontroller for low-level motor control, and worked on its CAN wiring and the overall electrical schematic. With our external partner, we discussed whether to map the exoskeleton to the humanoid joint by joint, which keeps the poses matched but can make the robot miss what the operator reaches for, or by matching the position of the hands, which keeps the hands aligned but not the joints.

Current status

Personal contributions

Team member Personal contribution
Vishesh Garg Designed the Teensy CAN wiring, worked on the overall control system, and wrote an application for additional capstone funding.
Connor Switzer Worked on the electrical wiring and schematic, and selected electrical components like wire, CAN wire, and heat shrink.
Celine Ebrahimian Refined the MuJoCo simulation, worked on running it on the Jetson, and printed an initial scissor linkage test for the shoulder.
Callista Tan Soldered and brought up the Teensy, updated the electrical block diagram, and procured our wire stripper.
Laila Elhossini Prototyped the elbow and wrist joints, documented fit issues, and tested the wrist pulley system.