Week 6: PDP Presentation & High-Level Design
Week of October 19-23
This week we submitted and presented our PDP, and wrapped up phase two (high-level design) of our project plan with initial mechanism sketches and high-level block diagrams.
PDP presentation
The PDP combined our need, problem statement, objectives, constraints, and criteria with decision matrices for each actuation method (rotary, pulley-driven, pneumatic, and linear) at each joint. We submitted it on October 19 and presented to our professors on October 21.
Initial design work
With a rotary actuator selected for the elbow, and two linear actuators plus a cable for pronation/supination selected for the wrist, we sketched the initial mechanisms for these joints. In parallel, we drafted the electrical requirements and high-level block diagrams for the electrical and firmware systems.
Current status
- PDP submitted October 19 and presented October 21
- Phase two (high-level design) wrapped up
- Initial elbow and wrist mechanism sketches done
- Electrical requirements and electrical/firmware block diagrams drafted
Personal contributions
| Team member | Personal contribution |
|---|---|
| Vishesh Garg | Drafted high-level firmware block diagram and prepared firmware content for the PDP presentation. |
| Connor Switzer | Drafted electrical requirements and the high-level electrical block diagram covering power distribution and component connections. |
| Celine Ebrahimian | Consolidated decision matrices and firmware content into the PDP presentation. |
| Callista Tan | Contributed to the electrical block diagram and initial component selection. |
| Laila Elhossini | Produced initial elbow and wrist mechanism sketches for the high-level design. |